Luminex xPONENT 4.2 for FLEXMAP 3D Manuale Utente

Quick GuidexPONENT® for FLEXMAP 3D® SoftwareVersion 4.2

7. Type a name for the plate in the Plate Name box, or select a saved plate from the PlateName list.NOTE: If a saved plate is selected the results of

Revive After Storage RoutineNOTE: The Revive After Storage routine is necessary when the systemhas been idle for more than a week.After you have adjus

7. Load wells with at least five drops of the Calibration, Verification, and Fluidics beads, asindicated on the plate image and in the kit insert inst

4. Vortex the xMAP calibrator, verification, and fluidics containers for 30 seconds to ensurehomogeneity. Do not dilute xMAP calibrator, verification,

To run, print, and/or save a report:1. Open the Results page.2. Click the Reports tab.3. In the Report drop-down list, select the report that you want

You can create each quantitative, qualitative, and allele call protocols using one productcomposed of a definable number of standards and controls.The

6. Select Fit of all Standards or Mean of Replicates.7. Select Analyze results while acquiring samples if you want to view real-time analysis.8. Click

11. Add standards, controls, unknowns, and maintenance steps to the plate layout.12. Click Save to save the protocol. Creating a KitTo create a kit:1.

Create a BatchThere are three batch creation options:• Create a New Batch from an Existing Protocol (uses a protocol; described in thissection).• Crea

2. Select the Current Batch or Saved Batches tab.3. If you want to open a saved batch, highlight the batch and click Open. Shut Down the InstrumentRun

© Luminex Corporation, 2012. All rights reserved. No part of this publication may bereproduced, transmitted, transcribed, or translated into any langu

By Phone Inside the U.S. and CanadaContact Luminex Technical support at:• Toll Free: 1-877-785-BEAD (-2323)• Fax: 512-219-5114By Phone Outside the U.S

Table of ContentsStartingxPONENT®...

xPONENT™ for FLEXMAP 3D®iv

StartingxPONENT®• On the PC desktop, click the Luminex® xPONENT® icon, or click Start > All Programs >Luminex > xPONENT > Luminex xPONENT.

Software OverviewxPONENT® software is organized into a series of pages. As you click each page, applicabletabs open on the left-hand side of the windo

Results - Analyze previously acquired batches; view current and saved reportsProtocols - Displays protocols, Stds & Ctrls, and Lot information.Mai

System Status Button - This button has two functions: When clicked, it opens the systemlog. It also displays the current status of the system. If ther

Adjusting the Sample Probe HeightAdjust the sample probe height to ensure that the probe drops far enough into the well toacquire sample.NOTE: Ensure